Oil layer filter oil pump, stainless steel, filter capacity 1.6 - 2.5 l/min, 10 plates 20 x 10 cm

Oil plate filter oil pump, stainless steel, filter capacity 1.6 - 2.5 l/min, 10 plates 20 x 10 cm

Special features of this pump are the low pressure and the low speed.

This allows for gentle filtration - pumping of high-quality food products.

The capacity of the filter consists of 10 plastic support plates for 10 filter layers. At least 2 filter layers with 3 plates are necessary for operation.

The required original filter papers can be found under the category Filter - Layer filter/Wine pump in various filtration finenesses.

The oil filter system is fully assembled and ready for operation. You only need to install your suction hose and pressure hose.

The suitable food-grade silicone hose with 10 mm inner diameter and 3 mm wall thickness can be found under the button Hoses/Food.

The strong wall thickness of 3 mm prevents the silicone hose from kinking on the 10 mm hose nozzle.

The hose holds on the conical hose nozzle without clamps.

To avoid possible loosening during the filtering process, it is advisable to use our 14 mm hose clamps.

Of course, the pump can also be used alone, without the filter, for transferring liquids. For example, for transferring oil into different tanks.

Due to its design, the pump is dry-running safe.

The side channel pump must be filled once with the medium to be conveyed, then it is permanently self-priming, as liquid always remains in the pump.

The pump type offers further design advantages:

air suction is possible without damage to the impellers
escape of the medium is impossible
there is no contact between the medium and the motor
low speed with high liter output

Further applications include operation in the filtration of wine, beer, spirits or fruit juices.

The depicted food-grade hose with 10 mm inner diameter is optionally available.

You can find this product under the button Hoses.

Approved media:

Wine, beer, spirits, vegetable oil, olive oil, fruit juice, water

The media to be conveyed must not contain any abrasive substances.

In this case, the pump must be equipped with a suitable pre-filter.

The viscosity must not be higher than max. 30 mm²/s.

The medium temperature must be below 36 °C.

Technical data:

Version AC 230 Volt nominal voltage

Delivery rate max 7 l/min at free discharge without layer filter

Delivery rate with layer filter approx. 1.6 - 2.5 l/min

max 1 bar

Self-priming 6 m height

Pump housing, shaft and impeller made of stainless steel

Seals NBR

rigid hose nozzles cast with the housing conical min 10 mm

2850 rpm

Motor 0.3 kW and 1.1 A

69 dB

4 kg pump with filter 12 kg

Dimensions:

210 x 120 x 190 mm pump

400 x 270 x 250 mm pump with filter frame