The season for condensation and rainwater in storage tanks for heating oil and diesel has begun again.
As every year in autumn and winter, you will find water at the bottom of your tank.
Our new product saves you extra filters and expensive cleaning and repumping of fuels in tanks where water has settled.
The failure of your machines, engines, heaters, etc., fueled with contaminated fuel, is a thing of the past.
Condensation and water from penetrating rain or melting snow always find their way through the tank's ventilation system.
You can remove this water easily and quickly with the Tank Dryer.
Through an opening of at least 5 cm, lower the Tank Dryer to the bottom of the tank using the attached cord.
The Tank Dryer has two weights inside the casing to allow the product to slide easily down to the bottom.
There, the Tank Dryer immediately starts to work.
After just one hour, you can pull the water-soaked product to the surface and inspect it.
The Tank Dryer must be checked after one week at the latest.
Tank Dryers saturated with condensation must be removed immediately.
The approx. 58 cm long product is able to absorb up to 400 ml of water.
If you suspect a lot of water in the storage tank, you can, of course, lower several Tank Dryers into the tank at once.
The effectiveness of the Tank Dryer is reduced if alcohol-based additives are present in the fuel.
Do not use the product if the fuels are ethanol-based.
Cord length approx. 2.24 m
Weight 75 g
Water in diesel and heating oil tanks removed with Tank Dryer
